Search results for "Triethylene glycol"

Reduced protein adsorption on plastics via direct plasma deposition of triethylene glycol monoallyl ether

1997

The direct plasma-induced deposition of tri(ethylene glycol) monoallyl ether is reported. RF plasma polymerization of this monomer was carried out under both continuous wave (CW) and pulsed plasma operation. The major focus of this work was optimization of the degree of retention of the C-O-C bonds of the starting monomer during the deposition process. This successfully was accomplished using low RF power during the CW runs and low RF duty cycles during the pulsed plasma experiments. Spectroscopic analysis of the plasma films revealed a strong dependence of film composition on the RF power and duty cycles employed. In particular, an unusually high level of film chemistry compositional contr…

Linear Organo-Soluble Poly(p-benzamide)

2009

Organo-soluble, shape-persistent oligo- and poly(p-benzamide)s were synthesized and characterized. A triethylene glycol (TEG) substituent was introduced to the p-aminobenzoic acid monomer structure as a solubilizing side chain giving 4-amino-2-triethylene glycol benzoic acid. This new monomer was polymerized by the facile polycondensation of the corresponding acid halide derivative of the amine hydrochloric salt. Additionally, a well-defined heptamer was prepared from this monomer on a peptide synthesizer as a model compound. The TEG-substituted oligomers and polymers exhibited good solubility yet high aggregation tendency in common polar and nonpolar organic solvents. The solution self-org…

Polarity profiles in reverse micelles of Triton X-100, as studied by spin probe and absorption probe techniques

1997

The microenvironment characteristics — polarity, viscosity and order degree - in Triton X-100 reverse micelles (RM) in cyclohexane and benzene — n-hexane 30 : 70 (v/v), were investigated with the aid of a homologous series of cationic spin probes, CAT n, of 5- and 16-doxyl stearic acids and of a new absorption probe, 4-nitropyridine-N-oxide (NP). The spectral parameters were related to local hydration values by means of a series of poly(oxyethylene) (PEO)/water calibration mixtures. All results regarding the polarities in RM and calibration mixtures have been expressed in terms of Kosower's Z values, by determining the linear dependence of the transition energies of NP, ENP, on Z, for a ser…

Sensitivity analysis and process optimization of a natural gas dehydration unit using triethylene glycol

2019

Abstract Dehydration of natural gas by absorption using triethylene glycol (TEG) is a common industrial offshore procedure to ensure the compliance with the required water dew point specifications for midstream transportation. Two thermodynamic models, the UMR-PRU and the TST/NRTL, are applied for the process simulation while a preliminary economic evaluation has been conducted revealing that both yield overall similar results as for the fixed capital cost which is found to be in good agreement with reported literature values. Moreover, sensitivity analysis of several operational parameters of the process has been performed and optimized values are suggested aiming to reduce its energy requ…

1990

The countercurrent extraction method recently developed for the continuous polymer fractionation (CPF) was applied to linear polyethylene (Mw = 55 kg/mol; Mn = 16,7 kg/mol). At temperatures higher than 130°C, moderately concentrated solution of polyethylene were extracted to remove the low-molecular-weight components. Discontinuous fractionation experiments served to detect the best suited solvents. Diphenyl ether was chosen to demonstrate that the present extraction can be performed even with the same single solvent used to prepare the feed. For very high-molecular-weight polymers, mixed solvents are, however, normally better than single ones, since they allow an easier tailoring of thermo…

Preparation of monodisperse polyethylene oxides by gel permeation chromatography of discontinuous polymer-homologous series

1970

Abstract Starting from triethylene glycol, monodisperse polyethylene oxides of a molecular weight (MW) up to 2000 (degree of polymerisation (DP) During the first step the ditosylate of triethylene glycol is reacted with the sodium alkoxide of the same diol at room temperature. The condesation product (polymer homologues of triethylene glycol) was separated by molecular distillation and yielded the pure oligomers nonaethylene glycol (DP = 9, MW 414) and pentadecaethylene glycol (DP = 15, MW = 678), as proved by gel chromatography. During the next step the polymer homologues of nonaethylene glycol were synthesised in a similar way. The pure oligomers hepteicosa (DP = 27, MW = 1207) and pentat…

1977

The reaction of ethylene glycol, 1,4-butanediol, 1,6-hexanediol, 3,6-dioxaoctane-1,8-diol (triethylene glycol), poly(ethylene oxide)s with Mn = 300,1000 and 3000, or with poly(propylene oxide)s with Mn = 425 and 2000 in excess with AIBN leads to the corresponding bis(hydroxyalkyl) 2,2′-azodiisobutyrates (1a–i). These initiators are suited to synthesize telechelics. With equimolar amounts of AIBN and 3-oxapentane-1,5-diol (diethylene glycol), poly(ethylene oxide)s with Mn = 300, 1000 and 12000, poly(propylene oxide) with Mn = 425, or with poly(tetrahydrofuran) with Mn = 1000 and 2000 polymeric azoinitiators of structure 2 are formed. Blockcopolymers may be synthesized by means of these polym…